News:

Welcome ZX10R Ninja Owners!!!!!
Front Page Here
Can all new members that haven't posted please read the admin and announcement page for the forum rules.

Main Menu

Gear lever mod

Started by andicog, September 21, 2013, 07:24:22 PM

Previous topic - Next topic

andicog

Well I really want a nice set of rearsets (a cheap danmoto set would do . .) but with my insurance now due the funds are a little low, so an old set of Oberon pegs I had were caustic dipped and finished with a scotch pad before the bolts were replaced but from underneath, new brackets from Demon tweeks sale rail sorted the fitting but then I noticed how much slop there was in the original gear levers bushing, reconing it cant help the gear change due a lot of movement at the levers tip I removed the lever and pressed out the original crap bush, the hole in the lever is 14mm so I ordered some small bearings with a 14mm O/D and 8mm I/D, these are a push fit into the lever, the lever is 15mm wide and the bearings are 4mm, I used 3 bearings (12mm total width) and a small spacer although you could just get 4 bearings in and in hindsight it would be easier with 4. I then staked the lever around the bearings to prevent any problems with them coming out, a couple of thin shims either side and a new M8 bolt and it all works a treat, no slop and hopefully a slightly slicker shift. If anyone wants to try it the bearings are 1482RS and simply bearings do them for around £3.50 each free post.  :icon_thumright:







Age And Treachery Shall Always Triumph Over Youth And Skill . . . . . . .

Jak

You're an engineer Andi, that's worth a pony  :icon_thumleft: