News:

Welcome ZX10R Ninja Owners!!!!!
Front Page Here
Can all new members that haven't posted please read the admin and announcement page for the forum rules.

Main Menu

Fresh air system blanking plates

Started by Telboye, February 24, 2010, 05:35:53 PM

Previous topic - Next topic

Telboye

Does anyone know where I can get blanking plates for the fresh air system, for an 08/09 model 10R?
Arrow Full Evo System, K&N Race filter, PCV+SFM, Dynojet QS, Smog block off plates, Custom map, 520 chain/sprocket conversion, Airflow screen, Renthal Kevlar grips, Valter Moto Race filler cap, Brembo HPK Front Discs, Hel Braided lines, Bendix pads, Maxton Shock, Carbon F/Guard, TaylorMade Undertray

tony83

yes had some made up thru racefit they copied a set i bought, horse has a load of them. will fit your bike 15 quid a pair although your model will need an fi fix. also need to plug hole left in airbox.

can buy kits off ebay for £35 with plates, fi fix & plug so its up to you...
//http//: [insert/quote/here]

Nutz

W'as this bout then???

Spill the beans?

jimhas7

Work experience : Discoverer of caves behind waterfalls, slayer of Demons, spent a short time (a very short time) as keeper of the Heavenly stables (a very over-rated job if you ask me). Currently bodyguard to the jibbering fool Tripitaka (who doesn't appreciate me at all) and full time Great Sage..

r1ninja

Makes it easier to setup the bike on a dyno as you aren't feeding crankcase breather fumes back into the airbox

www.r1forum.co.uk

No-one needs more than seven fifty

tony83

Quote from: r1ninja on February 24, 2010, 08:28:27 PM
Makes it easier to setup the bike on a dyno as you aren't feeding crankcase breather fumes back into the airbox

almost... gives better a/f readings as exhaust gases not diluted with fresh air so easier to tune (and service with  less clutter) most dyno operators just pinch rubber tube whilst on dyno when probe in exhaust so readings not affected.

crankcase breather is whole other story, needs oil catch tank and breather filter to route/vent crankcase pressure (dirty/oily air) to atmosphere rather than back into engine, thereby helping high end rpm bhp.

bikes route these fumes back into airbox for emissions reasons...
//http//: [insert/quote/here]

Telboye

Quote from: tony83 on February 24, 2010, 05:48:44 PM
yes had some made up thru racefit they copied a set i bought, horse has a load of them. will fit your bike 15 quid a pair although your model will need an fi fix. also need to plug hole left in airbox.

can buy kits off ebay for £35 with plates, fi fix & plug so its up to you...

Yes I am interested, what is the fi fix and what does it consist of?
Arrow Full Evo System, K&N Race filter, PCV+SFM, Dynojet QS, Smog block off plates, Custom map, 520 chain/sprocket conversion, Airflow screen, Renthal Kevlar grips, Valter Moto Race filler cap, Brembo HPK Front Discs, Hel Braided lines, Bendix pads, Maxton Shock, Carbon F/Guard, TaylorMade Undertray

Telboye

Quote from: tony83 on February 24, 2010, 09:36:03 PM
Quote from: r1ninja on February 24, 2010, 08:28:27 PM
Makes it easier to setup the bike on a dyno as you aren't feeding crankcase breather fumes back into the airbox

almost... gives better a/f readings as exhaust gases not diluted with fresh air so easier to tune (and service with  less clutter) most dyno operators just pinch rubber tube whilst on dyno when probe in exhaust so readings not affected.

crankcase breather is whole other story, needs oil catch tank and breather filter to route/vent crankcase pressure (dirty/oily air) to atmosphere rather than back into engine, thereby helping high end rpm bhp.

bikes route these fumes back into airbox for emissions reasons...

Yup that's about the size of it :-P Crescent do a really nice catch tank for the GSXR1000, not sure if I'm gonna go that far (but then again)
Arrow Full Evo System, K&N Race filter, PCV+SFM, Dynojet QS, Smog block off plates, Custom map, 520 chain/sprocket conversion, Airflow screen, Renthal Kevlar grips, Valter Moto Race filler cap, Brembo HPK Front Discs, Hel Braided lines, Bendix pads, Maxton Shock, Carbon F/Guard, TaylorMade Undertray

tony83

can get catch tanks off ebay for £30 quid, they do various options for entry/exit just need 1/2 inch heater hose and a mini breather filter. Halfords do some ripspeeds for a tenner but i got a mini K&N for £18.

only prob is where to put it lol.

seen a few race bikes with them up under rear seat where tool kit normally lives...

http://cgi.ebay.co.uk/Harris-spondon-streetfighter-oil-catch-tank_W0QQitemZ330405526683QQcmdZViewItemQQptZUK_Motorcycle_Parts?hash=item4cedb43c9b
//http//: [insert/quote/here]

Telboye

Quote from: tony83 on February 25, 2010, 07:55:44 PM
can get catch tanks off ebay for £30 quid, they do various options for entry/exit just need 1/2 inch heater hose and a mini breather filter. Halfords do some ripspeeds for a tenner but i got a mini K&N for £18.

only prob is where to put it lol.

seen a few race bikes with them up under rear seat where tool kit normally lives...

http://cgi.ebay.co.uk/Harris-spondon-streetfighter-oil-catch-tank_W0QQitemZ330405526683QQcmdZViewItemQQptZUK_Motorcycle_Parts?hash=item4cedb43c9b

Cheers bud much appreciated.
Arrow Full Evo System, K&N Race filter, PCV+SFM, Dynojet QS, Smog block off plates, Custom map, 520 chain/sprocket conversion, Airflow screen, Renthal Kevlar grips, Valter Moto Race filler cap, Brembo HPK Front Discs, Hel Braided lines, Bendix pads, Maxton Shock, Carbon F/Guard, TaylorMade Undertray

tony83

fi fix will be a resistor for the connector that plugs into the solenoid/valve assy so ecu thinks its still there...
//http//: [insert/quote/here]

Telboye

Quote from: tony83 on February 25, 2010, 10:25:09 PM
fi fix will be a resistor for the connector that plugs into the solenoid/valve assy so ecu thinks its still there...

Thanks for that, do you know what resistance the resistor should be?

Cheers
Arrow Full Evo System, K&N Race filter, PCV+SFM, Dynojet QS, Smog block off plates, Custom map, 520 chain/sprocket conversion, Airflow screen, Renthal Kevlar grips, Valter Moto Race filler cap, Brembo HPK Front Discs, Hel Braided lines, Bendix pads, Maxton Shock, Carbon F/Guard, TaylorMade Undertray