News:

Welcome ZX10R Ninja Owners!!!!!
Front Page Here
Can all new members that haven't posted please read the admin and announcement page for the forum rules.

Main Menu

New number plate regs in force

Started by JediZX10R, April 30, 2009, 07:54:38 PM

Previous topic - Next topic

Prilla

I think it was sn4 - 2009........ 27.4.09.  I read it the same way as geemonster, as per my earlier post, but the SN is not the best worded document. You have to read it a couple of times to work out what's relevant and what is now obsolete.

I test at a different garage to where our workshop is so will re-read next time I'm down there. 

geemonster

Agreed its not the most visualy written and straight forward of documents. The obsolete bits are at the lower box sections

JediZX10R

I will also recheck it when i get back to work on tues. Attached to the special notice pages 4 and 5 are the new rfr's it states we must fail for those items
even though the rfr's in the tetsers manual have not been updated. i will post the wording of the notice tues eve.

JediZX10R

Looks like i read it wrong. It says its abolishing the rules that arnt inforce. Oh well got everyone chatting  :emb:

Chrisblack10r

i must of read it wrong????

cause it goes on about all the failers for number plates

and then the failers for toe bars


Volkswagen Master Technician with an 08 zx10r with 181.4 BHP at the back wheel hahaha!!!!!

Andy J


Chrisblack10r

will have another look tomoz, SN04-2009 is the number of it

as said it lists all the reasons for rejections and then there sub sections within the mot testers manual


Volkswagen Master Technician with an 08 zx10r with 181.4 BHP at the back wheel hahaha!!!!!

geemonster

I'd be the first to say I read it wrong so was baffled, usually I steam in without reading warnings and advice tips haha. Good job I'm not a Tester. Got people fired up though I must admit!! My bikes still gonna fail though due to noisy unbaffled racefit and monster background on the plate...boohoo!!!

:tongue2:

Prilla

Quote from: Prilla on May 01, 2009, 12:05:33 AM
Maybe I read the VOSA wrongly, but I read it as the following: bikes registered from sept 2001,  honeycomb and non standard country type logos, as well as background shadows etc were a failure, BUT the ruling about postcodes and suppliers name is now obsolete and there is no longer a rfr (reason for refusal) for postcodes and suppliers name and therefore CANNOT BE FAILED FOR THESE REASONS.

I'll have another read before I do another mot but I'm sure that's the case.

Well that's cleared that up then. :shock:  

I'm a friendly MOT tester by the way. :icon_thumleft:

So was I right then? Haven't had a chance to re-read it yet.

JediZX10R

just confusing when they tell you to ignore something we've been ignoring for 18 months  :icon_scratch:

Chrisblack10r

am of the opposite thought, i could of sworn it said to now enforce it as of 1st april 2009

again will re read, print off and type up if i can remember


Volkswagen Master Technician with an 08 zx10r with 181.4 BHP at the back wheel hahaha!!!!!

Prilla

Thanks. If you could post it up then maybe we could have a vote as to what we (the 10 massive) think it means.

It's never straightforward. Most of the MOT stuff is now open to interpretation.......... noisy race cans for one. :shock:


Chrisblack10r

#42
right, had a good read through the special notice today

as of the 27th april 2009 some of the rules on nunberplate regulations ARE reinstated, here it is word for word

Reinstatment of certain registration plate checks

Following the suspension of certain registration plate checks in Novemeber 2007, a number of the suspeneded Methods of Inspection and Reasons for Rejection are to be reintroduced from the 27th April 2009.

The Sections of the Manual this applies to are:       Class I, II, III, IV & VII Section 6.3
                                                                                                     Class V section 6.12

The references in the following table list the specfic Reasons for Rejection to be re-introduced and which will be available for selection on the VTS Device from 27th April 2009


  • A front reg plate does not have the black characters on a white background

    A rear reg plate does not have black characters on a yellow background

    The reg plate background overprinted or shadowed with text e.g. vehicle manufacturer name

    The reg plate obviously displaying a honeycomb or similar effect background

    A reg plate with a non-reflective border obviously wider than permitted or positioned too close to the characters

The references in the following table list the specific Reasons for Rejection which are now OBSOLETE and will remain UNAVAILABLE for selection


  • A reg plate obviously not displaying the name and postcode of the supplying outlet

    A reg plate obviously not displaying a BSAU 145d marking

    A dual purpose reg plate displaying a symbol other than an acceptable international symbol or flag


Volkswagen Master Technician with an 08 zx10r with 181.4 BHP at the back wheel hahaha!!!!!

Chrisblack10r

hope this clears the situation up boys


Volkswagen Master Technician with an 08 zx10r with 181.4 BHP at the back wheel hahaha!!!!!