Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[slapknacker]

right does anyone know where i can get a part for my
brembo master cylinder?

you see after swapping the lever the w.end i have lost the
little roll pin which secures the adjuster knob on the shaft

i have a faint memory of a service place near silverstone

any help much appreciated.

cheers Daz.

[Andy J]

maybe give Demon Tweeks a call they are usually pretty helpful 

[Shotgun]

Try this one mate
http://www.moto-racing.co.uk/cat--Brembo-All-Spares-and-Accessories--Brembo+All+Spares.html

[davemfox]

...or PDQ

http://www.pdq1.com/

Dave

[doug_zx10r]

I've got a feeling I lockwired mine, the rollpin only matters if you adjust the lever often.

[NinjaPaul]

I just put a small split pin in mine.

[slapknacker]

Try this one mate
http://www.moto-racing.co.uk/cat--Brembo-All-Spares-and-Accessories--Brembo+All+Spares.html

thanks bud, i'll take a look

[slapknacker]

...or PDQ

http://www.pdq1.com/

Dave

chers Dave i will check it out

[nuddy]

[fatboy racing]

on Brembo M/C its reccomemnded that you lockwire this pin and they do have a habbit of dropping out

[budda10r]

Not likely on mine I can't get the bugger out.

[slapknacker]

on Brembo M/C its reccomemnded that you lockwire this pin and they do have a habbit of dropping out

are you sure? i'm talking about the minute roll pin that holds the span
adjuster in place. doubt wether you would get lock wire through that 

but the pivot pin has a habit of comming out if the circlip goes astray

[slapknacker]

Not likely on mine I can't get the bugger out.

so did the pazzo arrive ok then mate

you need to use a small drill bit to tap it out slightly then pull it out
with a pair of pliers. otherwise you will loose it like i did

[budda10r]

Yes mate thanks a lot it looks great, however I had a mare with the pin in my brembo so its sitting on the shelf at my work abode at the mo.

It will be fitted this week though, I got the clutch lever as well so it'll look good I hope.

Thanks again.....................

The part that needs lockwire/tie wrap is the pin that the lever pivots on, the circlip can come off and the pin may fall out which equals no brakes Anyone with a Brembo fitted should do this before using the bike again it may save your life!!!

P.S. Iv'e got a hell of a hangover today!!!

[slapknacker]

hangovers eh, bloody hate them.
feel for ya.

i had one sat morn, went out with an old pal for abeer friday eve.
only 2 pints i said to my misses. came back at 2am totaly wankerd.
she slept in the spare room, kids up at half 6 and they wreked my head
all day. hangovers and kids dont mix at all