Gallery > Modification Gallery

Chinese fairing review

<< < (2/3) > >>

maddog:
The wheels btw are black with rim tape on.......do you think i should use white wheels or keep them black?

seddo:
Have you tried black wheels with green tape?

maddog:
Not yet mate but thats a good shout!  [clap]

seddo:
Im using green tape meself on them when i buy them. if i had them done id show a pic but in the middle of the make over meself. Im going for a bright green when i do buy some

maddog:
Now the sun is out i managed to almost fit them. They are not properly fitted but will go into detail in a bit.





The problem i had was, a couple of mounting points on the nearside were about 3/4 cm out so i had to re drill them.  They are still within the recessed area but right on the edge. When they are fitted you wont notice unless its pointed out

They are not properly fitted yet as im going to take them off and give the bike a proper service before using it. 

I will get a photo during the week. It was no major issue just frustrating

So far, im pretty happy with the quality. They are nice and bright and look the nuts.

The front and offside fitted a treat and the only issue ive had is with the nearside, however....drilling a couple of holes wasn't hard at all. If i had a heated garage with power in it would have been a doddle to fit

I will update when they are fully fitted.

Navigation

[0] Message Index

[#] Next page

[*] Previous page