Bike Stuff > Two Wheel waffle for all
200mph Club
michael4012:
The engine is all finished & ready fit but as my skills & knowledge have improved iv learned to check the valve to piston clearance by pressing the valve down whilst reading a dial gauge so im waiting on a another gasket coming from the US :icon_thumright: & then i will be asking you to run her in on the dyno :-P
ZedThou:
Looking forward to seeing the results on the dyno
michael4012:
--- Quote from: ZedThou on January 18, 2015, 10:07:53 AM ---Looking forward to seeing the results on the dyno
--- End quote ---
If i get + 25BHP then i will be very happy :icon_thumright: That would be 195 on the wheel :-P
ZX10Rich:
--- Quote from: michael4012 on January 18, 2015, 10:19:54 AM ---
--- Quote from: ZedThou on January 18, 2015, 10:07:53 AM ---Looking forward to seeing the results on the dyno
--- End quote ---
If i get + 25BHP then i will be very happy :icon_thumright: That would be 195 on the wheel :-P
--- End quote ---
If you get that I will be very happy, I don't think its going to be that much but would like to be proved wrong, aim for a small number then anything above will make you happy lol, torque should show a big leap though. Either way its going to be a great motor.
Chappo:
Watching this with an eagle eye, good luck guys hope you get there :icon_thumright:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version